AEG RCB53724MW 사용자 설명서 - 페이지 10

{카테고리_이름} AEG RCB53724MW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG RCB53724MW 16 페이지.
AEG RCB53724MW에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

www.aeg.com

Problem

The compressor does not

start immediately after

pressing the FROSTMATIC

or after changing the tem-

perature.

Water flows inside the re-

frigerator.

Water flows on the floor.

Temperature cannot be set. The FROSTMATIC or

The temperature in the ap-

pliance is too low/too high.

Side panels of the appli-

ance are warm.

Possible cause

The room temperature is

too high.

Food products placed in

the appliance were too

warm.

The FROSTMATIC function

is switched on.

This is normal, no error has

occurred.

The water outlet is clog-

ged.

Food products prevent wa-

ter from flowing into the

water collector.

The melting water outlet is

not connected to the evap-

orative tray above the com-

pressor.

COOLMATIC function is

switched on.

The temperature regulator

is not set correctly.

The food products temper-

ature is too high.

Many food products were

stored at the same time.

The FROSTMATIC function

is switched on.

This is a normal state

caused by operation of the

heat exchanger.

Solution

Refer to climate class chart on

the rating plate.

Allow food products to cool to

room temperature before stor-

ing.

Refer to "FROSTMATIC func-

tion".

The compressor starts after

some time.

Clean the water outlet.

Make sure that food products

do not touch the rear plate.

Attach the melting water out-

let to the evaporative tray.

Switch off FROSTMATIC or

COOLMATIC manually, or wait

until the function resets auto-

matically to set the tempera-

ture. Refer to "FROSTMATIC

or COOLMATIC function".

Set a higher/lower tempera-

ture.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Store less food products at the

same time.

Refer to "FROSTMATIC func-

tion".