AEG SANTO C 7 18 40-4I 작동 및 설치 지침 - 페이지 12

{카테고리_이름} AEG SANTO C 7 18 40-4I에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG SANTO C 7 18 40-4I 14 페이지. Integrating fridge freezer
AEG SANTO C 7 18 40-4I에 대해서도 마찬가지입니다: 작동 및 설치 지침 (15 페이지), 작동 및 설치 지침 (28 페이지), 작동 및 설치 지침 (24 페이지), 작동 및 설치 지침 (25 페이지), 작동 및 설치 지침 (28 페이지), 작동 및 설치 지침 (32 페이지), 작동 및 설치 지침 (32 페이지), 작동 및 설치 지침 (28 페이지), 사용자 설명서 (44 페이지)

Open the door and push the

appliance against the side of the

kitchen unit opposite to that of

appliance hinges.

Fasten the appliance with 4

screws provided in the kit

included with the appliance.

Snap vent grille (C) and hinge

cover (D) into position.

Apply covers (B) on joint cover lugs

and into hinge holes.

Separate parts A, B, C, D as shown in

the figure

D723

D726

PR266

Starting up and temperature regulation of

freezer compartment

• Turn the temperature regulator (B) in the direction of "1". The green(A)

comes on. The freezer motor starts up.

• Psuh the

Normal/Super push button

Setting "0": Off.

Setting "1": Hightest temperature, (warmest setting).

Setting "4" (end-stop) : Lowest temperature, (coldest setting).

The exact setting should be chosen keeping in mind that the temperature

inside the appliance depends on:

- the quantity of food stored

- how often the door is opened

- ambient temperature

Quick-freezing

For quick-freezing, push the Normal/Super button (D). The super

control light (C) will then light up.

The Quick-freezing function accelerates the freezing of fresh food

and, at the same time, protects foodstuffs already stored from

undesirable warming.

If this function is not ended manually, the appliance switches off

the Quick-freezing function after 52 hours. The yellow light goes

out.

This function can be ended manually at any time by pressing the

Normal/Super button again. The yellow light goes out.

(D), the yellow light (B) comes on;