AEG SANTO C 7 18 41-4I 작동 및 설치 지침 - 페이지 21

{카테고리_이름} AEG SANTO C 7 18 41-4I에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG SANTO C 7 18 41-4I 28 페이지. Integrating fridge freezer
AEG SANTO C 7 18 41-4I에 대해서도 마찬가지입니다: 작동 및 설치 지침 (15 페이지), 작동 및 설치 지침 (29 페이지), 작동 및 설치 지침 (28 페이지)

페이지 인쇄
AEG SANTO C 7 18 41-4I 작동 및 설치 지침

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb,
switch off the appliance and unplug it, or pull the fuse or the circuit breaker.
Light bulb data: Replace the lamp with one of the same power (the
maximum power is shown on the light diffuser).
1.
To switch off the appliance, press the ON/OFF buttons (I).
2.
Unplug the mains plug.
3.
To change the light bulb press on the
rear hook and at the same time slide
the cover in the direction indicated
by the arrow.
4.
Change the defective light bulb.
5.
Refit the light bulb cover.
6.
Put the refrigerator back into opera-
tion.

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured in
accordance with the appropriate standards. The necessary measures in
accordance with appliance safety legislation regulations (GSG), accident
prevention regulations for refrigeration appliances (VBG 20) and the regu-
lations of the German Society of Electrical Engineers (VDE) were observed in
the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
This appliance is in accordance with the following EU guidelines:
– 73/23/EWG dated 19 February 1973 - low voltage guidelines.
– 89/336/EWG dated 3 May 1989
(including guideline change notice 92/31/EWG) - EMV guideline
21