AEG SANTO C 7 18 41-4I 작동 및 설치 지침 - 페이지 7
{카테고리_이름} AEG SANTO C 7 18 41-4I에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG SANTO C 7 18 41-4I 28 페이지. Integrating fridge freezer
AEG SANTO C 7 18 41-4I에 대해서도 마찬가지입니다: 작동 및 설치 지침 (15 페이지), 작동 및 설치 지침 (29 페이지), 작동 및 설치 지침 (28 페이지)
페이지 인쇄
Shelf holders
Your appliance is equipped with shelf
retainers that make it possible to
secure the shelves during transporta-
tion.
To remove them proceed as follows:
Raise the shelf from the back, push it
in the direction of the arrow until it
is free and remove the retainers.
Installation
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance should
therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, or other sources of heat;
– only be installed at a location whose ambient temperature corresponds to
the climate classification, for which the appliance is designed.
The climate classification can be found on the rating plate, which is loca-
ted at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for each
climate classification: each climate classification:
Climate classification
If the refrigeration appliance is installed next to another refrigerator or free-
zer a clearance of 5 cm at the sides is required, in order to prevent the for-
mation of condensation on the outside of the appliance.
Important: if the supply cord is damaged, it must be replaced by manufac-
turer , its service agent or similarly qualified persons in order to avoid a
hazard.
SN
N
ST
T
for an ambient temperature of
+10 bis +32 °C
+16 bis +32 °C
+18 bis +38 °C
+18 bis +43 °C
7