AEG 1200 D 작동 및 설치 지침 - 페이지 9

{카테고리_이름} AEG 1200 D에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 1200 D 19 페이지.

Carbon filter

The activated carbon filter should only be used if you want to use

the hood in its filtering function.

To do this you will need an original AEG activated carbon filter (see

special accessories).

l Cleaning/replacing the carbon filter

Unlike other carbon filters, the LONGLIFE carbon filter can be

cleaned and reactivated. At normal use the filter should be cleaned

every second month. The best way to clean the filter is in the

dishwasher. Use normal detergent and choose the highest tempe-

rature (65º C). Wash the filter separately so that no food parts gets

stuck on the filter and later causes bad odours. To reactivate the

carbon, the filter should be dried in an oven for 10 minutes with a

temperature of maximum 100º C.

After approximately three years of use, the carbon filter should be

replaced with a new, as the odour reduction capacity will be

reduced.

l Mounting

Remove the grease filters and fit one LONG LIFE carbon filter S

on the rear side of each grease filter, fix each with two metal wires

Z . Fig. 5.

To dismount proceed in reverse order.

Always specify the hood model code number and serial number

when ordering replacement filters. This information is shown on the

registration plate located on the inside of the unit.

The activated carbon filter can be ordered from the AEG technical

assistance service.

Fig. 5