AEG 1300 D 운영 및 설치 매뉴얼 - 페이지 5

{카테고리_이름} AEG 1300 D에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 1300 D 14 페이지. Cooker hood

Introduction

• The hood is supplied as an extractor unit and can also be used with

a filtering function by fitting one activated carbon filter (special

accessory).

• You will need original AEG activated carbon filter for this function

(see Special Accessories).

• The unit features two outlet holes, one of which A is located on the top

of the unit while the other B is located on the rear.

• To connect up the hose, you should first fit the bayonet-mounting

flange C (Ø 120 mm) on the outlet required (if using the top outlet, fix

the flange in place using the screw supplied as shown in Fig. 1).

Close off the unused hole using the bayonet fitting caps D.

Fig. 1

• Warning! If is decided to use the rear outlet hole B, first remove the

sponge E that closes that hole. Fig. 2.

• The air is filtered and recirculated

through the front grid.

•

Move the lever G to position F - Fig.

• You will need an original AEG

KF12/13 activated carbon filter

for the filtering function. (See

Special Accessories).

Fig. 2

Fig. 3