AEG 2600 D 작동 및 설치 지침 - 페이지 5

{카테고리_이름} AEG 2600 D에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 2600 D 20 페이지.
AEG 2600 D에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (16 페이지)

• The air outlet must not be connected to chimney flues or combustion

gas ducts. The air outlet must under no circumstances be connected

to ventilation ducts for rooms in which fuel-burning appliances are

installed.

• It is advisable to apply for authorization from the relevant controlling

authority when connecting the outlet to an unused chimney flue or

combustion gas duct.

The air outlet installation must comply with the regulations laid down

by the relevant authorities.

• When the unit is used in its extractor version, a sufficiently large

ventilation hole must be provided, with dimensions that are

approximately the same as the outlet hole.

• National and regional building regulations impose a number of

restrictions on using hoods and fuel-burning appliances connected to

a chimney, such as coal or oil room-heaters and gas fires, in the

same room.

• Hoods can only be used safely with appliances connected to a

chimney if the room and/or flat (air/environment combination) is

ventilated from outside using a suitable ventilation hole approximately

500-600 cm

large to avoid the possibility of a depression being

created during operation of the hood.

• If you have any doubts, contact the relevant controlling authority or

building inspector's office.

• Since the rule for rooms with fuel burning appliances is "outlet hole of

the same size as the ventilation hole", a hole of 500-600 cm

is to say a larger hole, could reduce the performance of the extractor

hood.

• If the hood is used in its filter version, it will operate simply and

safely in the above conditions without the need for any of the

aforementioned measures.

• When the hood is used in its extractor function, the following rules

must be followed to obtain optimal operation:

— short and straight outlet hose

— keep bends in outlet hose to a minimum

— never install the hoses with an acute angle, they must

always follow a gentle curve only

— keep the hose as large as possible (preferably the same diameter

as the outlet hole).

• Failure to observe these basic instructions will drastically reduce the

performance and increase the noise levels of the extractor hood.

, which