AEG 3010 D 운영 및 설치 매뉴얼 - 페이지 7

{카테고리_이름} AEG 3010 D에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 3010 D 19 페이지. Aeg cooktop user manual
AEG 3010 D에 대해서도 마찬가지입니다: 작동 및 설치 지침 (17 페이지)

페이지 인쇄

LED Indicator lights for veryfying the

saturation of filters

This hood is supplied without a charcoal filter. If the hood is to be used

in the recirculation mode with a charcoal filter, the saturation indicator

must be activated as follows:

Depress and hold the B and G buttons simultaneously for 3 seconds.

Initially only the LED indicator signal for the grease filter D is activated,

shortly after the LED indicator for the charcoal filter E will activate, at

this point the saturation detection has been enabled.

To switch off the saturation detection : depress and hold the B and G

buttons for 3 seconds until the LED indicator for the active carbon filter

is flashing.

Led – Indicator for grease filter D

The LED indicator for the grease filter will flash when it requires

cleaning.

Follow the maintenance instructions.

Led - indicator for charcoal filter E

The LED indicator for the charcoal filter illuminates when the filter

requires replacing.

This occurs after about 160 working hours from when the active carbon

filter was first put into operation.

Resetting the saturation indicator

After cleaning or replacing the filter depress and hold the A button again

for 3 seconds until the grease filter LED D or the charcoal LED E are no

longer flashing.