AEG 9000 Series 사용자 설명서 - 페이지 24
{카테고리_이름} AEG 9000 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 9000 Series 32 페이지.
AEG 9000 Series에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지), 사용자 설명서 (8 페이지)
페이지 인쇄
24
www.aeg.com
Problem
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
programme or
option.
It is not possible
to select an op‐
tion. An acoustic
signal is emit‐
ted.
There is no
drum light
Unexpected du‐
ration time ap‐
pears on the
display.
A programme is
inactive.
Possible cause
Incorrect programme selection.
The filter is clogged.
Dryness Level option was set to
3)
iron dry .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possi‐
ble to change the programme or
option.
The option you tried to select is not
available for the selected pro‐
gramme.
Defective drum lamp.
The drying duration is calculated
according to load size and damp‐
ness.
The water container is full.
Remedy
Select a suitable programme.
2)
Clean the filter.
Change Dryness Level option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Contact the service centre to re‐
place the drum lamp.
This is automated - the appliance
is working correctly.
Drain the water container, push the
2)
Start/Pause button.
1)
4)
2)