AEG 942 022 081 사용자 설명서 - 페이지 10
{카테고리_이름} AEG 942 022 081에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 942 022 081 12 페이지.
10
www.aeg.com
Keep the hood
clean
Charcoal filter
6.2 Cleaning the grease filter
Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip
on the filter panel underneath the
hood.
2
2. Slightly tilt the front of the filter
downwards, then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
4. To mount the filters back follow the
first two steps in reverse order.
Clean the appliance and grease filters each month. Clean the interior
and grease filters carefully from fat. Fat accumulation or other residue
may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle.
The grease filter may discolour, it has no influence on the performance
of the appliance.
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter. The acti‐
vated charcoal filter is not washable, cannot be regenerated and must
be replaced approximately every 4/6 months of operation, or more fre‐
quently for particularly heavy usage.
1
Repeat the steps for all filters if
applicable.
6.3 Replacing the charcoal
filter
WARNING!
The charcoal filter is non-
washable!
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Press the front edge in slot towards
the bottom part of the filter. Slightly
tilt the front of the filter downwards.
3. To install a new filter, perform the
same steps in reverse order.
In any case, it is necessary to replace
the filters at least every four months.
6.4 Replacing the lamp
This appliance is supplied with a LED
lamp and separate control gear (LED