AEG CHDF 6260 운영 및 설치 매뉴얼 - 페이지 4

{카테고리_이름} AEG CHDF 6260에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG CHDF 6260 21 페이지. Electrolux cooktop user manual
AEG CHDF 6260에 대해서도 마찬가지입니다: 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (21 페이지), 운영 및 설치 매뉴얼 (22 페이지), 작동 및 설치 지침 (23 페이지), 작동 및 설치 지침 (22 페이지)

페이지 인쇄

For the installer

• Only for model DF6160: when used as an extractor unit, the hood

must be fitted with a 120mm diameter hose.

• Only for models DF 6260 - DF 6260-ml/1 and CHDF 6260: when

used as an extractor unit, the hood must be fitted with a 150mm

diameter hose.

Only for model DF 6260 - DF 6260-ml/1: should there already be a

hose of diameter 125 mm that ducts to the outside through the walls

or roof, it is possible to use the 150/125 mm reduction flange

provided. In this case the hood will be slightly more noisy.

• When installing the hood, make sure you observe the

following minimum distance from the top edge of the

cooking hob/ring surfaces:

electric cookers

gas cookers

If the instructions for installation for the gas hob specify a greater

distance, this must be adhered to.

• The national Standard on fuel-burning systems specifies a maximum

depression of 0.04 mbar in such rooms.

• The air outlet must not be connected to chimney flues or combustion

gas ducts. The air outlet must under no circumstances be connected

to ventilation ducts for rooms in which fuel-burning appliances are

installed.

• The air outlet installation must comply with the regulations laid down

by the relevant local authorities.

• When the unit is used in its extractor version, a sufficiently large

ventilation hole must be provided, with dimensions that are approxi-

mately the same as the outlet hole.

• National and regional building regulations impose a number of

restrictions on using hoods and fuel-burning appliances connected to

a chimney, such as coal or oil room-heaters and gas fires, in the

same room.

• Hoods can only be used safely with appliances connected to a

chimney if the room and/or flat (air/environment combination) is

ventilated from outside using a suitable ventilation hole approximately

500-600 cm

created during operation of the hood.

• If you have any doubts, contact the relevant controlling authority or

building inspector's office.

• Since the rule for rooms with fuel burning appliances is "outlet hole of

the same size as the ventilation hole", a hole of 500-600 cm

is to say a larger hole, could reduce the performance of the extractor

hood.

large to avoid the possibility of a depression being

430 mm

650 mm

, which