Kohler 10EKD 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Kohler 10EKD에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 10EKD 17 페이지.
Kohler 10EKD에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)

페이지 인쇄

Install the flow switch.

7.1

For Units Without a Siphon Break:

Note: Proceed to Section 7.2 for units with a

siphon break.

7.1.1 Remove

between the heat exchanger end cap and

catalyst. See Figure 13. Save the molded

hose for re-use.

1. Remove this hose.

Figure 13 Hose Location (Units Without Siphon

Break)

7.1.2 Install a new hose (X-312-42), flow switch

(GM90436), and hose fittings (GM90472

qty. 2) as shown in Figure 15.

Note: Use Teflon tape on the threads of

the flow switch fittings. Wrap the

tape around at least 3 times.

Note: Avoid any kinks in hoses that

connect to the flow switch.

7.1.3 Reuse the molded hose (removed in

Step 7.1.1) but spin the hose 180_ from its

original position. See Figure 15, item 1.

7.1.4 Secure the hoses using hose clamps

(X-426-12 qty. 2) and existing hose

clamps.

7.1.5 Connect the flow switch connector to the

new wiring harness connector that was

routed to the nonservice side in Step 5.2.

the

molded

hose

located

GM58158-L

7.2

For Units With a Siphon Break:

7.2.1 Remove the hose located between the

heat exchanger end cap and the hose

connector. See Figure 14.

7.2.2 Cut this hose into a 4-inch piece and a

5-inch piece.

1. Remove this hose.

Figure 14 Hose Location (Units With Siphon Break)

7.2.3 Reuse the

Step 7.2.2) as shown in Figure 15, item 4.

Install the flow switch (GM90436), and

hose fittings (GM90472 qty. 2) as shown in

Figure 15.

Note: Units equipped with a siphon break

will not use the new hose X-312-42

supplied in the kit.

Note: Use Teflon tape on the threads of

the flow switch fittings. Wrap the

tape around at least 3 times.

Note: Avoid any kinks in hoses that

connect to the flow switch.

7.2.4 Reuse the

Step 7.2.2) as shown in Figure 15, item 2.

7.2.5 Secure the hoses using hose clamps

(X-426-12 qty. 2) and existing hose

clamps.

7.2.6 Connect the flow switch connector to the

new wiring harness connector that was

routed to the nonservice side in Step 5.2.

GM60007-A

hose (cut to 4 inches in

hose cut to 5 inches in

TT-1617

12/13