AEG DD 8990 작동 및 설치 지침 - 페이지 7

{카테고리_이름} AEG DD 8990에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG DD 8990 21 페이지. Aeg ventilation hood user manual
AEG DD 8990에 대해서도 마찬가지입니다: 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (23 페이지), 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (21 페이지), 작동 및 설치 지침 (21 페이지)

will automatically turn off after 5 minutes.

To interrupt the Intensive speed, press button 1 or 5.

The letter P appears on the display and the remaining time (the

point "a" is flashing), if interrupted an acoustic signal is heard.

7 - Self-Timer: times all the speed levels (the point "b" is flashing),

and then the cooker hood switches off:

The self-timer is set as follows:

1st speed level 20 minutes

2nd speed level 15 minutes

3rd speed level 10 minutes

P (intensive) speed level: 5 minutes

The display shows the remaining operation time, at the end of the

time an acoustic signal is heard. Depressing the push-button

again exits the function.

Automatic Sensor calibration:

The automatic calibration is carried on by the hood itself every 30

minutes.

When the hood is installed for the first time or the power is cut off

for many hours or days, please wait 30 minutes before the use or

make a manual calibration.

Manual Sensor calibration

Carry out calibration with the hob off, at normal ambient room

temperature and in the absence of an appreciable amount of

steam:

- press switch 4 for about 3secs , then press switch 1, the hood

emits a sound signal to indicate calibration taking place.

Sensors test

When functioning in Automatic mode, the system continuously

tests the efficiency of the sensors. In case of a fault the display

shows "88". Contact your local Service Force Centre.

In this situation the hood can, in any case, be used in the manual

mode.

Safety procedure

Self-activation of Automatic (SAFETY) mode:

if the sensors reveal an excessive increase in temperature,

even if the hood is in Manual mode, the system self selects the

Automatic mode and the hood selects the necessary speed.

The hood can be turned off by pressing push switch 1.

Should the hood or the controls fail to operate: disconnect the power

supply for at least 5 seconds.

After reconnecting the power supply wait 15 seconds and then check

that the cooker hood is now operating correctly.