AEG DD6490-M 사용자 설명서 - 페이지 12

{카테고리_이름} AEG DD6490-M에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG DD6490-M 32 페이지. Cooker hood aeg dd6460-m; dd6490-m
AEG DD6490-M에 대해서도 마찬가지입니다: 사용자 설명서 (28 페이지)

페이지 인쇄
AEG DD6490-M 사용자 설명서
�
Button
Function
A
Turns the suction motor on and off at speed
one.
B
Decreases the working speed.
C
Increases the working speed.
D
Activates intensive speed from any other speed,
including motor off. This speed is set to operate
for 5 minutes, after which the system returns to
the speed that was set before. Suitable to deal
with maximum levels of cooking fumes.
When the filters alarm is triggered, the alarm can
be reset by pressing and holding this button for
ap-proximately 3 seconds. These indications are only
visible when the motor is turned off.
E
Delay function
Activates automatic switch-off with a 20' delay.
Suit-able to complete elimination of residual
odours. Can be activated from any position, and
is disabled by pressing the button or turning the
motor off.
Press and hold the button for approximately 5
sec-onds, with all the loads turned off (Motor
and Lights), to turn the Activated Charcoal Filter
alarm On and Off.
F
Turns the lighting system on and off at maximum
intensity.
Activation of the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a
later date.
• Press and hold button E (Delay) for 5 seconds, until confirmation appears on the display:
C flashes twice – Activated Charcoal Filter saturation alarm ACTIVATED.
•
C flashes once – Activated Charcoal Filter saturation alarm DEACTIVATED.
•
12
EN
�
�

Charcoal filter (recycling version)

�
�
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays HI and the time remaining once every
second.
F indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
C indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 200 working hours.
Displays the operating speed and the dot at the bottom
right flashes alternately with the remaining time.
- C flashes twice - A.C. Filter alarm Activated.
- C flashes once - A.C. Filter alarm Deactivated
�