A-Neuvideo ANI-HDR-200 사용 설명서 - 페이지 7
{카테고리_이름} A-Neuvideo ANI-HDR-200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neuvideo ANI-HDR-200 11 페이지. Hdmi 18gbps over hdbasettm 2.0 w/ arc transmitter & receiver
페이지 인쇄
A
NEUVIDEO
Receiver
POWER LED:
System power indicator.
q
ARC LED:
ARC status indicator.
w
ARC BUTTON:
This button will enable or disable the ARC function.
e
• Enable ARC: LED ON
• Disable ARC: LED OFF
• ARC function: If you need to use ARC, your HDTV must support this function, when you open the ARC function, the transmitter
optical out port will output the HDTVs current display content audio signal, otherwise the transmitter optical out port signal will come
from the Receiver's Optical In.
DC 24V:
Connects 24V/1A adaptor to AC wall outlet for power supply.
r
HDBaseT
IN:
Connects to HDBaseT
™
t
IR IN:
Connects to a Wideband IR RX cable.
y
IR OUT:
Connects to a Wideband IR TX cable.
u
OPTICAL IN:
Connects to the audio source device such as a DVD or Blu-ray player for sending audio signal to the Transmitter.
i
HDMI OUT:
Connects to the HDMI display device.
o
LAN:
Connects to an active network for LAN sharing for a total transmission rate up to 100Mbps. Or when a compatible LAN equipped
a
Transmitter is connected to an active network, this allows the network access (including internet access if available) to be shared between
the Transmitter and Receiver.
NOTE: Do not connect this RJ-45 port to any of the HDBaseT
RS-232:
Connects to any devices with RS-232 port for RS-232 commands transmission.
s
SERVICE SEL 1/2:
Reserved for firemware update use only.
d
OPERATION CONTROLS & FUNCTIONS
Transmitter with a CAT5e/6/7 cable.
™
ports. This may damage this port or the whole device.
™
5