A-Neuvideo ANI-9251RX 사용 설명서 - 페이지 7

{카테고리_이름} A-Neuvideo ANI-9251RX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neuvideo ANI-9251RX 12 페이지. Hdcp 2.2 & hdmi 2.0 extender with oar / audio insertion for use with the ani-1082uhd
A-Neuvideo ANI-9251RX에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

Operation controls & Functions

Front Panel

q POWER LED:

w OPTICAL IN:

sends audio to the Transmitter.

e IR IN 1:

IR IN 1 is considered an IR receiver which connects to the supplied IR Receiver

cables for IR signal reception. Ensure that remote being used is within the direct line-of-

sight of the IR Extender.

r IR OUT 2:

IR Out 2 is considered an IR BLASTER which connects to the supplied IR

Blaster cable for IR signal transmission. Place the IR Blaster in direct line-of-sight of the

equipment to be controlled.

t RS-232:

Connects to the device that is to be controlled (via RS-232 terminal connected

with a D-Sub 9-pin cable) by ASCII commands.

y UPDATE:

When updating the firmware, the switch should be moved to the left side. As

indicated by the arrows on the case.

This power LED will illuminate when receiving power from the transmitter.

Connects with an optical audio source as an optical audio return which