AEG mintie ECU4 소유자 매뉴얼 - 페이지 4

{카테고리_이름} AEG mintie ECU4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG mintie ECU4 17 페이지.

INITIAL SET UP

Part A: Initial Set Up of ECU4 Frame

With ECU4 frame removed from box, set base of the unit on the floor as shown. (Fig: A-1)

2. Place your hands on the two corner posts above locking collar plastic sliders with rings to start unfolding

the frame. (Fig: A-1) CAUTION: Do not grasp Outer Legs below plastic sliders during opening of ECU4

Frame

to prevent accidental pinching of fingers.

3. While standing on one end of the two shorts sides of the frame, step down on lower end truss locking

it into place. (Fig: A-2).

4. Remove the cotter pins holding the long side lower truss in their storage position to each corner post and

and lower each long side truss to the oor and secure with pins. (Figs: A-3, A-4)

5. Finish by pushing up on each Plastic Slider to lock the frame in the fully deployed position (you will hear an

audible click). (Fig: A-5)

6. Place the two top truss pieces onto the corner post caps and swing the folding short arms securing them

with the push button pin latch to nish the frame deployment. (Figs: A-6)

7. Remove the self adhesive memory foam from the inner box, peal the protective adhesive shield and apply to

top edge of the upper truss pieces. (Figs: A-7)

(Fig: A-2)

(Figs: A-1)

(Fig: A-5)

(Fig: A-7)

www.mintie.com

Mintie LLC.® ECU4

(Fig: A-6)

1-800-9MINTIE

(Figs: A-3)

(Fig: A-6)

(Fig: A-7)

1-323-225-4111

(Figs: A-3)

(Fig: A-4)

(Fig: A-6)

(Fig: A-7)