AEG protect d. 2000 설치 및 운영 지침 매뉴얼 - 페이지 12

{카테고리_이름} AEG protect d. 2000에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG protect d. 2000 25 페이지. Fume extractor hood

Select the hood operating mode

Extractor operation

Fix the 150 mm diameter ABS pipe to the hood outlet and

ensure that the other end discharges into the open air.

The hood is supplied with a reducer for 120 mm diameter

pipes. This reducer must be mounted on the hood outlet.

Filter operation

If the connector ring has not yet been installed, it must be

fitted at this point (Q Q Q Q Q in

Fig. 7

Fig. 7, bayonet

Fig. 7

connector). Turn it in a

clockwise direction and

fix it to the air pipe L

using a screw. Insert the

air pipe into the

telescopic chimney

support and fix it with

four screws (Ø 2,9 x 9,5

mm). Fig. 7

Fig. 7

Fig. 7.

Fig. 7

Fix the 150 mm diameter

ABS pipe to the hood

outlet, and connect it to

the air pipe connector

ring.

For both versions:

The hood can now be connected to the power supply.

If a gas non-return valve has been installed or is required,

ensure that it opens and closes properly.

Fix the top part the telescopic outlet pipe to the relative

support, using the two 3 mm dia x 9 mm screws R. R. R. R. R. Fig. 6.

Slide the bottom part of the telescopic outlet pipe

downward until it rests in its housing on the top of the

hood.

Replace the grease filters.

Fig. 7

Fig. 6.