Kohler SUMMON K-24147T-7 설치 및 운영 지침 - 페이지 3

{카테고리_이름} Kohler SUMMON K-24147T-7에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler SUMMON K-24147T-7 5 페이지. Sensor faceplate(ac, w/ music)

B: Faceplate Installation

1. After the transformer and the circuit are properly connected,

the in wall tank is installed according to the installation

instructions until the construction of the false wall in front of

the water tank is completed.

2. Install pump control module assembly to faceplate body,

connect emergency flush air hose to outlet pipe in air

cyclinder. Connect output signal cable and input signal

cable together, and tighten nut. See figure

3. Connect big flush air hose and half flush hose to outlet joint

in pump control module assembly. Connect power output

cable of transformer and power input cable of faceplate

body together, and tighten nut. See figure

Note: Cut the excessive parts of air hose if necessary

and fix it onto the tank fastener.

4. When tighten four locknuts on faceplate body, adjust to

"OPEN" mark as shown. See figure

5. Tighten four fixed tubes to "LOCK" mark after installing

faceplate body as shown. See figure

1385914-T01-A

Pump Control Module Assembly

Air Cyclinder

Manual Flush

Full Flush

Half Flush

Emergency Flush

Air Hose

Full Flush Air Hose

Half Flush Air Hose

OPEN

Faceplate Body

Fixed Tube

-3-

Output Signal Cable

Input Signal Cable

Faceplate Power Input Cable

Transformer Power

Output Cable

LOCK