Kohler TOUCHLESS 32323T-4 매뉴얼 - 페이지 11
{카테고리_이름} Kohler TOUCHLESS 32323T-4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler TOUCHLESS 32323T-4 13 페이지.
페이지 인쇄TROUBLESHOOTING
CAUTION: Risk of product damage. This product contains sensitive electronic components. Use care not to damage
pins and connectors during troubleshooting.
Symptoms
1. No water flow.
A. The supply stops are closed.
B. Handle is in the closed position.
C. The hot and/or cold supply hose is
kinked.
D. Battery power is low or exhausted.
E. Clogged sprayhead or valve box
screen.
2. Low water flow.
A. The supply stops are partially closed.
B. Handle is partially closed.
C. The hot and/or cold supply hose is
kinked or twisted.
D. One or more screens are clogged.
E. Cracked diaphragm.
3. Poor spray
A. The spray nozzles are clogged.
pattern.
4. Water drip or
A. Manual override is partially engaged. A. Turn the manual override counter-clockwise as far as
trickle when faucet
is not in use.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft cloth.
Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely affect the
finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
"LEAD FREE" is marked on the back of the faucet signifying its compliance with the United States AB1953
1435817-2-B
Faucet Troubleshooting Table
Probable Causes
Recommended Actions
A. Confirm the supply stops are open.
B. Rotate the handle to the open position. Refer to the
"Operation Instruction" section.
C. Confirm the supply hoses are not kinked. If coiled,
maintain an inside diameter of minimum Ø76mm.
D. Check for a red flashing LED on the sensor. If it flashes
red, refer to valve box installation instruction 1431520-2
for batteries replacement.
E. Refer to the "Care and maintenance" section.
A. Confirm the supply stops are fully open.
B. Rotate the handle to the full open position.
C. Confirm the supply hoses are not kinked or twisted.
If coiled, maintain an inside diameter of minimum Ø76mm.
D. Refer to the "Care and maintenance" section.
E. Replace the valve box assembly.
A. Rub your finger over the nozzles with water running to
dislodge debris.
possible. Then turn the manual override clockwise until
the water stops dripping.
5