Kohler 1.1785.001 설치 매뉴얼 - 페이지 27

{카테고리_이름} Kohler 1.1785.001에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 1.1785.001 41 페이지. Thermostatic electric shower

Post Installation Procedure

Turn on the electrical

supply.

5 secs

Start the shower to test for water

flow and run for at least 1 minute. If a

shower drain pump is fitted, it should

also start. If there is no water after 5

seconds, make sure that appliance

has been primed.

P u s h S t a r t / S t o p t o t u r n o ff

appliance. Pulsing start/stop light

and "beep" indicates that appliance

is shutting down.

Turn on the power to appliance,

check Start/Stop for white light.

The shower will beep once when start/stop

button is pressed (3 times for BEAB mode).

The white start/stop and blue status light will

pulse and shower will beep again. After a few

seconds the shower will beep again and the

lights will go solid. This will confirm flow and

cold temperature.

Appliance will purge water from heater tank

for a few seconds.

Important! DO NOT isolate power until water

has stopped.

Turn the temperature to

full cold.

BEAB X 3

1306246-W2-D