Kohler Awaken R72421T 설치 지침 - 페이지 2
{카테고리_이름} Kohler Awaken R72421T에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Awaken R72421T 2 페이지.
페이지 인쇄
安裝步驟
如何安裝手持花灑
裝手持花灑(1)之前，先打
開水源約一分鐘沖洗掉雜
質。
根據需要將單向閥(2)放入
到花灑進水端。將濾網墊片
(3)放入花灑軟管(4)接頭
內，連接手持花灑與軟管。
注意: 不要過分擰緊。
軟管另一端連接水源。
如何操作手持花灑
轉動花灑面板上的旋鈕即可
調節花灑的各種水流模式。
如何維護保養花灑
噴孔雜質或結垢會導致水流
變形，流量變小。打開水
源，用力按壓或摩擦橡膠噴
孔，去除雜質或水垢。
取下軟管接頭內的濾網墊
片，去除雜質。
清理說明
適用於所有加工處理過的表面：以中性
肥皂水清洗鍍層表面，再以乾淨的軟布
徹底地擦乾整個表面。有許多清潔劑，
比如氨水，去污粉及潔廁靈等，會對電
鍍表面造成傷害，切忌使用。
有磨損性的清潔用具或清潔劑也不可使
用於 KOHLER 的水龍頭及其配件上。
INSTALLATION
How to Install the Hand Shower
Flush both water supply for about one
minute before the hand shower(1) is
installed.
Install check valve(2) into the shower
inlet if needed. Put the screen
washer(3) into the shower hose(4)
connector. Attach the hand shower to
shower hose.
Note: Don't over tighten.
Connect another end of shower hose
to the water supply.
How to Operate the Hand Shower
Rotate the knob of the hand shower to
change the water flow.
How to Maintain the Hand Shower
Any debris or mineral build-up may cause
the flow stream to become distorted or
reduce the flow rate. To remove the
debris or mineral build-up, run water
through the hand shower, firmly press or
rub your finger back and forth across the
rubber nozzles.
Remove and clean the screen washer.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals, such
as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended
for cleaning.
Do not use abrasive cleaners or solvents on Kohler
faucets and fittings.