Kohler BELAY K-23769T-RCP 설치 지침 매뉴얼 - 페이지 15

{카테고리_이름} Kohler BELAY K-23769T-RCP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler BELAY K-23769T-RCP 23 페이지.

페이지 인쇄

1. Installation Instructions

Press the air system button a third time to operate

at low speed.

Press the air system button a fourth time to shut off

the air system.

When you are done bathing, open the drain and

remain seated while the water drains from the bath.

When the water has drained from the bath, unlatch

and open the door.

Carefully exit the bath.

IMPORTANT!

A built-in timer automatically stops the

blower and motor after approximately 20 minutes of

operation.

IMPORTANT!

This product contains an automatic

water purge mode that turns the blower on for 15

seconds approximately 15 minutes after the unit is

turned off and drained.

Press once for high flow.

Press a second time for medium flow.

Press a third time for low, "Back Only" flow.

Press a fourth time to turn off.

Keypad Operation

Power Icon - Turns the heater on and off.

Heat/Temperature Indicator - The [Flame] icon

illuminates yellow, orange, or red depending on the

heat level. Yellow indicates low heat, orange

indicates medium heat, and red indicates high heat.

Up Arrow - Increases the temperature.

Down Arrow - Decreases the temperature.

NOTICE:

The heater will remain on until it is manually

turned off by pressing the [Power] icon.

NOTE:

After 60 minutes of inactivity, the heater will

automatically reset to low heat if the temperature was

set to medium or high. The heater will remain on at low

heat until it is manually adjusted or turned off.

NOTE:

The heater will turn on at the last selected

temperature setting.

1397340-T01-A

-15-

- [

]

[

]