Kohler Components 77984T-9E 설치 지침 - 페이지 2

{카테고리_이름} Kohler Components 77984T-9E에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Components 77984T-9E 2 페이지. Floor mount bath filler with handshower

페이지 인쇄

HANDLE OPERATION

Turn the upper handle clockwise for cold water; Turn the lower handle counter-clockwise for hot water.

Lift and turn the diverter for handshower. Turn the diverter in the normal position for bath spout.

INSTALLATION

1327567-AN2-D

How to Install the Faucet

Shut off water supply. Cut away the extending

part of the base protector(1) in accordance with

the tile surface. Remove the plug(2) from the

base. Remove the protector(3) from the faucet.

Slide up the escutcheon kit(4). Install the faucet.

NOTE: Keep the faucet vertical to the base, to

avoid damaging the O-rings on the bottom.

Keep the "KOHLER" logo on the body pointing

to tub. Fix the faucet to the base with the

screws(5) and washers(6) through the flange(7).

Tighten the screws with hex wrench(8).

Slide down the escutcheon kit, make sure it is

against the finished floor.

How to Install the Spout

Remove the protector(10) from the spout(9).

Install the spout into the body. Position the

spout. Make sure it is vertical to the handles.

Tighten the screws(11). Insert the plugs(12).

How to Install the Handshower

Remove the protector(10) from the connector

(13) of the diverter kit. Connect the hose(14)

to the diverter kit and handshower(15) with

washers. Tighten all the connections.

Hang the handshower on the bracket(16).

Katalyst Air

INSTALLATION CHECKOUT

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft

cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could

adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

1327567-AN2-D

How to Operate the Handshower

Press the buttons of the handshower to

change water flow.

Intense Massage

How to Maintain the Handshower

Any debris or mineral build-up may cause the

flow stream to become distorted or reduce the

flow rate. To remove the debris or mineral

build-up, run water through the handshower,

firmly press or rub your finger back and forth

across the rubber nozzles.

Remove and clean the screen washer.

Ensure that all coupling nuts are tight.

Ensure that the handle is in the off position.

Turn on the main water supply, and check for

leaks. Repair as needed.

Remove the aerator(18) by key(17). Remove

the handshower(15). Turn on faucet handle.

Run hot and cold water through spout for

about one minute to remove any debris.

Check for leaks at this time. Remove any

debris. Shut off the faucet. Reinstall the

aerator and handshower.