Kohler Elosis K-18055T-B-CP 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} Kohler Elosis K-18055T-B-CP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Elosis K-18055T-B-CP 12 페이지. Sensor faucet
페이지 인쇄
1.电源盒 (背面有不干胶)应安装在干燥，不会被水
淋湿、浸泡的位置。根据需要客户自备穿线管及
连接线。穿线管安装在墙内。建议交流电源线采用
带绝缘和护套层的电线，导体标称截面积 0.5mm ;
直流连接线采用导体标称截面积
请严格按照上图进行连接。
2. 排线完毕后，应检查并确保所有排、接线无误，
再分别连接电源盒AC接线端与排线管内交流接线
端，以及电源盒DC接线端(黑橙线接头)与龙头的
电源线接插件（从阀盒内引出的电线），最后打
开AC电源，龙头进入2分钟自动调距阶段，此过
程龙头不会出水。
8
1.Power unit (sticker on the back) should be installed at
a dry place and avoid showering, soaking from water.
Customer prepare wire tube and wire according to
requirement. Wire tube should be mounted into the
2
wall. Suggested wire: AC connection wire adopts
2
mm 的电线。
0.3
wires with protecting layer or sleeve and the section
should be ≥ 0.5mm². The section of DC connection wire
should be ≥ 0.3mm². the connection pattern must
follow the illustrations above.
2.After wire layout finished, check and repair if needed.
Then connect AC connector to AC connector within
FPC pipe, DC connector (black-orange) on electrical
box to faucet power cord connector (wire from valve
box). Finally turn on AC power source, faucet enter
auto sensing distance adjusting phase about 2min. The
faucet will not work during this period.
1248536-T01-C