Kohler Englefield Valencia Elite 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Kohler Englefield Valencia Elite에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Englefield Valencia Elite 7 페이지. Corner sliding 12x9
Kohler Englefield Valencia Elite에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (15 페이지), 설치 지침 매뉴얼 (16 페이지), 설치 지침 매뉴얼 (14 페이지), 설치 지침 매뉴얼 (7 페이지), 설치 지침 매뉴얼 (16 페이지), 설치 지침 매뉴얼 (17 페이지)

페이지 인쇄

VALENCIA

/ VALENCIA ELITE

7 Drawer re-installation

a) To re-install the drawer, extend the runners.

Place the drawer onto the runners and slide it

back so that the runner hooks insert into the

rear of the drawer.

(b) Make sure the locator pins line up with the

holes in the bottom of the drawer and press

the drawer down so that the pins slot into place.

Locator pin

Hook the hinges onto the base plates and press

down as shown.

1278274-A02-D September 2023

Double Drawer Vanity

VALENCIA

5 Vanity top

(a) Unpack the top and check for any damage that

(b) Apply a continuous bead of silicone (not

Runner hook

*Mount Screws will

need to unscrewed

before removing the

drawer for latest

runners setup.

6 Waste and tapware

Hook

Page6

Vanity

INSTALLATION INSTRUCTIONS

8. Drawer Height Adjustment

(a) Remove the drawer. To tilt the drawer front

forward before adjusting the height of drawer.

might have occured in transit. Check and

confirm the fit of your selected tapware.

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely fitted to the cabinet and no water

spillage will find its way into the cabinet.

No silicone on

front edge

(b) Turn anticlockwise on the locator pin spacer

to raise the height of the drawer and turn clock-

wise to raise down. Repeat on the other runner.

Height Adjustment

that the back is flush against the wall and

there is an even overhang on either side of the

cabinet.

Note: All drawers are aligned during assembly. However

further adjustment is often required after installation.

Please ensure the cabinet has not been twisted

and installed correctly before adjusting.

(d) Wipe off any excess sealant.

9 Sealing

(a) All edges MUST be sealed with an approved

Silicone Sealant.

(a) Fit the waste and tapware. Connect the water

supply to the taps and waste pipe to the waste

outlet.

(b) Run hot and cold water and check for leaks.

When satisfied with the results move on to the

next section.

INSTALLATION COMPLETE

Runner hook

Front Sectional View

DOWN

engleﬁeld.co.nz

7 Dr

(a) T

(b) M

8 Se

(a) A

- B