Kohler K-1146 설치 매뉴얼 - 페이지 11

{카테고리_이름} Kohler K-1146에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1146 48 페이지. Bath whirlpool
Kohler K-1146에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (32 페이지), 설치 매뉴얼 (48 페이지), 설치 매뉴얼 (44 페이지)

페이지 인쇄

8. Make Electrical Connections

WARNING: Risk of electric shock. To reduce the risk of electrical shock, connect the pump and in-line

heater (if heater option included) to properly grounded, grounding-type receptacles protected by

Ground-Fault Circuit-Interrupters (GFCI's). Do not remove the plugs' grounding pins. Do not use

grounding adapters.

Pump Wiring

NOTE: The whirlpool model number is printed on a label near the whirlpool pump. This label also

identiﬁes the electrical rating of the whirlpool.

Your Kohler whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has

been completed at the factory. A licensed electrician must install a GFCI-protected, 120 V, 15 A, grounded

outlet. No other load should be on this circuit. Locate the outlet behind the whirlpool, and within 24"

(61cm) of the pump.

Plug the pump into this outlet.

NOTE: Make sure the air actuator tubing is securely attached to the pump, and is not kinked or damaged.

If a K-1639 Timer Kit will be used, install it now according to the instructions packed with the timer kit.

In-Line Heater Wiring

The in-line heater is equipped with a cord and plug. All wiring of the heater has been completed at the

factory. A licensed electrician must install a GFCI-protected, 120 V, 15 A, grounded outlet. No other load

should be on this circuit. Locate the outlet behind the whirlpool, and within 24" (61cm) of the heater.

Plug the in-line heater into this outlet.

9. Test Run the Whirlpool

Check all electrical connections, and make sure the electrical power to the whirlpool and in-line heater (if

equipped) is on.

Make sure all union connections to the pump and in-line heater (if if equipped) are securely hand

tightened.

Fill the whirlpool to a level at least 2" (5.1cm) above the top of the highest jet.

Verify that the pump banding straps have been cut (if applicable), and that the pump is resting directly on

the subﬂoor or whirlpool base.

Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

For additional information on whirlpool operation, refer to the "Conﬁrm Proper Operation" section.

Kohler Co.

Install a GFCI-protected 120 V, 15 A grounded outlet. Install a

second GFCI-protected outlet for H models for the in-line heater.

Plug the in-line heater

into this outlet.

Bond in accordance

with applicable codes

Plug the pump

into this outlet

Make sure air actuator tubing is

securely attached to the pump

1010564-2-B