AEG 916 098 769 사용자 설명서 - 페이지 23

{카테고리_이름} AEG 916 098 769에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 916 098 769 32 페이지.

AEG 916 098 769 사용자 설명서
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause button may flash continuously:
Possible cause
Appliance Motor overloaded.
Too much laundry or entrap in the
E5A
drum.
Internal fail. No communication be‐
tween electronic elements of the
appliance.
E97
The mains supply is unstable.
EH0
If the display shows other alarm codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the Tumble dryer check the table below for possible
solutions.
12.2 Troubleshooting
Problem
The tumble dryer is not connected
to the mains supply.
The door is open.
The tumble dry‐
er does not op‐
The On/Off button was not pushed. Push the On/Off button.
erate.
The Start/Pause button was not
touched.
The appliance is in standby mode.
Possible cause
Possible cause
Remedy
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the alarm code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Touch the Start/Pause button.
Push the On/Off button.
ENGLISH
23