Kohler K-11831 주택 소유자 매뉴얼 - 페이지 5
{카테고리_이름} Kohler K-11831에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-11831 21 페이지. Wall-mount lavatory faucet valve
Kohler K-11831에 대해서도 마찬가지입니다: 설치 매뉴얼 (28 페이지)
페이지 인쇄
Troubleshooting (cont.)
Symptoms
Probable
Causes
G. A flex hose
is kinked.
H. Hybrid
Energy Cell
(HEC) has just
been replaced.
I. HEC life
expired.
J. Bleed hole
in diaphragm
is plugged or
debris exists
on the seal.
K. Solenoid
does not work.
2.
Low flow.
A. Filter is
plugged.
B. Supply
pressure is
low.
C. Aerator is
plugged.
3.
Constant
A. Filter is
water flow.
plugged.
B. Diaphragm
seal is
damaged or
dirty.
C. Solenoid
does not work.
Sporadic
A. The faucet
4.
water flow.
is angled
incorrectly to
deck or
misaligned
with user area.
Kohler Co.
Recommended Action
G. Check the flex hoses to make
certain they are not kinked. If a
flex hose is kinked, disconnect it,
straighten, and reconnect.
H. Wait 2 minutes after replacing
batteries as the sensor cycles
through the automatic sensing
distance.
I. Replace the HEC.
J. Clean or replace the diaphragm.
K. Order a new solenoid service
kit.
A. Clean or replace the filter.
B. Check incoming water pressure.
Pressure should be at least 20 psi
(137 kPa).
C. Remove the aerator and clean it.
For calcium/mineral deposits, soak
the aerator plastic insert in a 50:50
mixture of vinegar and water. Soak
only the insert and no other
components.
A. Clean or replace the filter.
B. If the diaphragm is cut or torn,
order a new diaphragm assembly.
Clean or replace the diaphragm.
C. Order and install a new solenoid
assembly.
A. Verify that the faucet is mounted
according to the installation
directions. Ensure that the faucet is
installed in a position that is above
the rim of the lavatory.
5
1124216-5-B