Kohler K-1244 설치 매뉴얼 - 페이지 6

{카테고리_이름} Kohler K-1244에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1244 48 페이지. Bath whirlpool
Kohler K-1244에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (32 페이지), 주택 소유자 매뉴얼 (29 페이지), 설치 매뉴얼 (48 페이지), 주택 소유자 매뉴얼 (36 페이지), 주택 소유자 매뉴얼 (32 페이지), 설치 매뉴얼 (48 페이지), 설치 매뉴얼 (44 페이지), 설치 매뉴얼 (48 페이지), 설치 매뉴얼 (44 페이지), 주택 소유자 매뉴얼 (29 페이지), 설치 매뉴얼 (48 페이지)

1/16"

(2 mm)

Tile

Approved Tile Backing

2. Prepare the Site - Concrete Construction

CAUTION: Risk of product damage. Do not support the bath by the rim.

NOTICE: Unless otherwise speciﬁed, ﬂoor support under the bath must provide for a minimum of 80

lbs./square foot (390 kg./square meter) loading.

NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed

location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor

closer than 1" (2.5 cm) from the wall or other objects.

Make sure the ﬂooring offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

Construct brick or concrete supports.

Provide a 1/16" (2 mm) gap between the bath rim and the concrete or brick framing. Frame the

ﬂoor, or construct a frame for a raised installation, in accordance with the roughing-in information

packed with the bath.

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

Install the drain to the bath according to the drain manufacturer's instructions. Do not connect the

trap at this time.

Position a clean drop cloth or similar material in the bottom of the bath to protect the ﬁnish. Be

careful not to scratch the surface of the bath.

1040292-2-C

Bath

Brick

Tile

Approved Tile Backing

Brick

Apron Side

Kohler Co.