Kohler K-1248 설치 매뉴얼 - 페이지 14

{카테고리_이름} Kohler K-1248에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1248 44 페이지. Bath whirlpool
Kohler K-1248에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (32 페이지), 러프인 매뉴얼 (4 페이지), 설치 매뉴얼 (48 페이지), 설치 매뉴얼 (48 페이지)

페이지 인쇄

Troubleshooting Procedure (cont.)

Symptoms

3. Whirlpool stops automatically

before 18 minutes.

4. Pump does not prime. (Models

with support blocks only.)

5. Noisy operation.

6. Heater does not operate. ("H"

models only)

1010914-2-D

Probable Causes

B. Jet not installed correctly.

C. Jets are blocked.

A. The GFCI or ELCB trips.

B. Suction blocked.

C. Jets are blocked.

D. Motor overheated and

protection device activated.

A. Pump shimmed too high.

A. Pump banding straps have not

been cut. (Models with support

blocks only.)

B. Jet O-ring dislodged.

A. No power to heater.

B. Water temperature exceeds

104° F (40° C).

C. Heater does not work.

Recommended Action

B. Reinstall jet; check for O-ring

damage.

C. Remove blockage.

A. Identify source of fault, and

correct.

B. Remove obstruction.

C. Remove blockage.

D. Check for blockage at motor

vents. Remove blockage and

allow motor to cool.

Check for suction blockage.

Remove blockage and allow

motor to cool.

Check for jet blockage. Remove

blockage and allow motor to

cool.

A. Lower pump support bracket.

A. Cut pump banding straps with

tin snips.

B. Remove jet, replace and

lubricate O-ring, and reinstall

jet.

A. Reset the GFCI or ELCB.

B. Allow water to cool and heater

will reengage.

C. Replace heater.

Kohler Co.