Kohler K-14036 설치 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Kohler K-14036에 대한 설치 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-14036 16 페이지. Undercounter lavatories
Kohler K-14036에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (24 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

Install the Lavatory (cont.)

Waterproof any exposed areas of wood.

For Marble/Stone Countertops

Position the countertop upside down on foam padding to protect the surface.

Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the locations shown on the

template.

Using a setting tool and hammer, secure the anchors.

For All Installations

If the countertop has not been installed, install it at this time.

Drill the faucet holes according to the faucet installation instructions.

Install the faucet and drain according to the manufacturer's instructions.

NOTE: Do not use adhesives or adhesive sealants with this product. Only use

silicone sealant.

Apply a continuous bead of silicone sealant to the top surface of the lavatory rim

where it will contact the countertop.

For Marble/Stone Countertops: Install the lavatory to the countertop with the

clamps and anchor screws provided.

For Wood Countertops: Install the lavatory to the countertop with the clamps and

wood screws provided.

For Other Countertop Materials: Refer to the countertop manufacturer's

instructions for recommended fasteners.

NOTICE: Risk of product damage. Do not overtighten the clamps. Overtightening

may cause irreparable damage to the lavatory.

Position the lavatory squarely under the cutout before tightening the clamps.

Draw the lavatory rim up against the countertop until it is snug. Do not

overtighten.

Immediately wipe away any excess sealant and ﬁll any voids as needed. Allow

the sealant to set for 30 minutes before proceeding.

Connect and tighten the trap to the drain. Complete the water supply connections

to the faucet according to the instructions packed with the faucet.

Run water into the lavatory and check for leaks.

Installer le lavabo

Découper l'ouverture du comptoir en suivant avec précaution la ligne tracée du

gabarit. Placer le lavabo dans la découpe et vériﬁer l'ajustage.

REMARQUE: Utiliser les vis et les ancrages fournis pour comptoirs d'une épaisseur

minimale de 1" (2,5 cm). Utiliser des ancrages et des ﬁxations (non-fournis) pour des

comptoirs plus minces.

Pour des comptoirs en bois

Marquer et percer les trous pilotes des vis à bois aux emplacements illustrés sur le

gabarit.

Kohler Co.

1068257-2-H