AEG LAVATHERM 61270AC 사용자 설명서 - 페이지 16

{카테고리_이름} AEG LAVATHERM 61270AC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM 61270AC 20 페이지.
AEG LAVATHERM 61270AC에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 사용자 설명서 (24 페이지)

페이지 인쇄
AEG LAVATHERM 61270AC 사용자 설명서
16 www.aeg.com
Unsatisfac-
tory drying
results.
The door
does not
close.
Err (Error)
on the dis-
play.
Abnormally
elapsing
time on the
display.
Programme
inactive.
Drying cycle
too short.
Drying cycle
too long
The loading door is opened.
The On/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The condenser is clogged.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the po-
sition.
The laundry is locked between
the door and the seal.
You try to change the pro-
gramme or the function after
the start of the cycle.
The function you try to activate
is not applicable with the selec-
ted programme.
The time to end is calculated
on the basis of the volume and
dampness of the laundry.
)
The water container is full.
To small laundry volume.
The laundry is too much dried.
The filter is clogged.
5)
Too high volume of the load.
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applica-
2)
ble programme.
3)
Clean the filter.
Clean the condenser.
Obey the maximum load vol-
ume.
Clean the airflow grill in the
bottom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hard-
4)
ness
.
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
The automatic procedure —
this is not the appliance mal-
function.
Drain the water container
push the Start/Pause button.
Do the selection of time pro-
gramme.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Clean the filter.
Obey the maximum load vol-
ume.
3)
3)
,