AEG LAVATHERM T35850 사용자 설명서 - 페이지 18

{카테고리_이름} AEG LAVATHERM T35850에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM T35850 28 페이지. Exhaust dryer

Installation

3. Remove foil hose and polystyrene pad-

ding from the machine.

Fitting the vent hose

To simplify the installation, there is a choice of vent outlets: one at the back, the others in

the left and right-hand side. Connect the hose to whichever is the more convenient by

pulling the ring nut (A) from the vent outlet at the back, screwing it on to the hose and

pushing it firmly back into place. The unused vents should now be sealed with the special

snap covers provided.

If the hose is long and the room temperature low,

the moisture might condense to water inside the

hose. This is an unavoidable natural phenomenon.

To prevent this water from Iying in the hose or

flowing back into the tumble dryer, it is advisable

to drill a small hole (via. 3 mm) in the lowest point

of the hose and to place a small container below

it. (See picture, point B).

Once connected to the dryer, run the vent hose to

the desired outlet point, ensuring that the run's

overall length is less than 2 m, and that it contains

no more than two bends. As to the outlet itself, if

you have decided on a fixed wall/window grille, a

good local builder's merchant should be able to

supply you with the necessary fittings and installation advice.