AEG LAVATHERM T56830 사용자 정보 - 페이지 22

{카테고리_이름} AEG LAVATHERM T56830에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM T56830 33 페이지. Condensation dryer
AEG LAVATHERM T56830에 대해서도 마찬가지입니다: 사용자 정보 (33 페이지)

페이지 인쇄

125983990.qxp

2006-04-21

Drying results

unsatisfactory.

Loading door does not

close.

When pressing a button,

the corresponding

button flashes several

times.

Drum light does not

work.

PROGRAMME TIME display

changes erratically or stays

unchanged for a long

time.

Programme inactive,

EMPTY WATER display

illuminated.

07:12

Page 22

Problem

Possible cause

Wrong programme selected.

Lint filter clogged.

Heat exchanger clogged

with lint.

Overloading of laundry.

Ventilation slots in base

area covered up.

Residue on inside surface of

drum or drum ribs.

Conductance of water at

installation site differs from

standard setting of machi-

ne.

Fine strainer not in place

and/or large mesh filter not

locked in place.

Washing protection. After

the start of the programme,

the option can no longer be

set.

Programme selector in OFF

position.

Defective light bulb.

Programme time is correc-

ted automatically depen-

ding on type and volume of

laundry and level of dampn-

ess.

Condensate tank is full.

Remedy

Select a different program-

me the next time you dry

(see "Overview of program-

mes" section).

Clean lint filter.

Clean heat exchanger.

Observe recommended loa-

ding volumes.

Uncover ventilation slots in

base area.

Clean inside surface of

drum and drum ribs.

Re-programme standard set-

ting for degree of drying

(see 'Programming options'

section).

Install fine strainer and/or

snap large mesh filter into

place.

Turn the programme knob

to OFF Set the programme

again.

Turn programme selector to

LIGHT or to any programme.

Replace light bulb (see next

section).

Automatic process; this is

not a machine fault.

Empty condensate tank,

then start programme with

START/PAUSE button.