AEG LAVATHERM T57830 사용자 정보 - 페이지 16

{카테고리_이름} AEG LAVATHERM T57830에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM T57830 33 페이지. Condensation dryer

Changing programme

To change a programme which has been selected by mistake once the pro-

gramme has started, first turn the programme selector to OFF and then reset

the programme.

The programme can no longer be changed directly once the programme has

started. If nevertheless there is an attempt to change the programme on the

programme knob, the programme progress display and the maintenance indi-

cators flash. If an option button (excluding the AUDIBLE SIGNAL button) is

pressed, the corresponding indicator flashes several times. The drying pro-

gramme is not however affected by this (laundry protection).

1. Open loading door

Warning! Laundry and drum can become hot. Risk of burns!

2. Load or remove laundry items.

3. Close loading securely. Lock must audibly lock.

4. Press the START/PAUSE button to continue the drying cycle.

Once the drying cycle is complete, the END and CREASE GUARD dis-

plays light up. If the AUDIBLE SIGNAL button has been pressed, an

audible signal sounds intermittently.

The drying cycle is automatically followed by a crease guard phase

which lasts around 30 minutes. The drum rotates in intervals during this

phase. The laundry thereby remains relaxed and free of creases. The

laundry can be removed at any time during the crease guard phase. (The

laundry should be taken out towards the end of the crease guard phase

at the latest to prevent creases from forming.)

1. Open loading door

2. Before removing the laundry, remove lint from the micro-fine filer. It

is best to use a damp hand for this purpose (refer to "Cleaning and

maintenance" section).

3. Remove laundry.

4. Turn the programme selector to OFF.

Important! After each drying cycle

– clean the micro-fine filter and fine strainer,

– drain the condensate tank

(refer to the "Cleaning and maintenance" section).

5. Close loading door.