AEG TR818A2OB 사용자 설명서 - 페이지 5
{카테고리_이름} AEG TR818A2OB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR818A2OB 32 페이지.
페이지 인쇄
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
Ensure good air ventilation in the room where the
•
appliance is installed to avoid the backflow of
unwanted gases into the room from appliances
burning gas or other fuels, including open fires.
WARNING: Do not install the appliance in an
•
environment with no air exchange.
The appliance contains flammable gas, propane
(R290), a gas with a high level of environmental
compatibility. Keep fire and ignition sources away from
the appliance. Be careful not to cause damage to the
refrigerant circuit containing propane.
WARNING: In the appliance enclosure or in the built -
•
in structure, keep ventilation opening clear of
obstruction.
WARNING: Do not damage the refrigerant circuit.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Do not exceed the maximum load of 8,0 kg (refer to
•
the "Programme chart" chapter).
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Do not run the appliance without a filter. Clean the lint
•
filter before or after each use.
Do not dry unwashed items in the tumble dryer.
•
Items that have been soiled with substances such as
•
cooking oil, acetone, alcohol, petrol, kerosene, spot
removers, turpentine, waxes and wax removers
should be washed in hot water with an extra amount of
detergent before being dried in the tumble dryer.
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, rubber backed articles and clothes
or pillows fitted with foam rubber pads should not be
dried in the tumble dryer.
ENGLISH
5