AEG TR838P4OB 사용자 설명서 - 페이지 19
{카테고리_이름} AEG TR838P4OB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR838P4OB 36 페이지.
페이지 인쇄
maximum load amount for the
selected programme.
In case of drum overload,
the maximum declared load
indicator comes on again
with the
blinking. In this case, during
these 30 seconds, it is
possible to open the door
and remove the exceeding
garments. Once removed,
touch the Inicio/Pausa
button to start the
programme again. If the
laundry amount will not be
reduced, the programme
starts anyway. In this case, it
will be not possible to
guarantee the best results.
8.10 Program change
To change a program:
1. Push the On/Off button to turn the
appliance off.
2. Push the On/Off button again to turn
on the appliance.
3. Set a new program.
8.11 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Aviso
de Finalización/Conclusão option is
activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
symbol signals the
execution of the anti-crease
phase. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
indicator
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
• Room temperature is too low or too
8.12 Drum light on
Touch and hold down Silencioso button
by around 3 seconds.
The light inside the drum is on.
8.13 Possible causes of
unsatisfactory drying results:
• The filter is clogged. Clogged filter
• The airflow slots are clogged.
• The humidity sensor is dirty.
• The drum is dirty.
• Inadequate default dryness level
• Room temperature is too low or too
to turn the appliance off.
settings. See chapter
default dryness level
high. Optimal room temperature is
between 18°-25°C.
makes drying inefficient.
settings. See chapter
default dryness level
high. Optimal room temperature is
between 18°-25°C.
ENGLISH
19
Adjustment of
Adjustment of