AEG TR838P4OB 사용자 설명서 - 페이지 24

{카테고리_이름} AEG TR838P4OB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR838P4OB 36 페이지.

페이지 인쇄

www.aeg.com

Error code

EH0

If the display shows other error codes, deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

In case of different problem with the tumble dryer check the table below for possible

solutions.

11.2 Troubleshooting

Problem

The tumble dry‐

er does not op‐

erate.

Unsatisfactory

drying result.

Possible cause

The mains supply is unstable.

Possible cause

The tumble dryer is not connected

to the mains supply.

The door is open.

The On/Off button was not pushed. Push the On/Off button.

The Inicio/Pausa button was not

touched.

The appliance is in standby mode.

Incorrect program selection.

The filter is clogged.

Nivel de Sec. option was set to

seco plancha/engomar .

The load was too large.

The airflow slots are clogged.

There is some dirt on the humidity

sensor in the drum.

The dryness level was not set to

the desired level.

The condenser is clogged.

When the appliance is showing

EH0, please wait until main supply

is stable than press start. If the ap‐

pliance pause the cycle without

any indication then press the cycle

start. If the warning will occur

check the power cord / socket in‐

tegrity or main supply.

Connect it to the mains socket.

Check the fuse in the fuse box (do‐

mestic installation).

Close the door.

Touch the Inicio/Pausa button.

Push the On/Off button.

Select a suitable program.

Clean the filter.

Change Nivel de Sec. option to a

higher level.

Do not exceed the maximum load

size.

Clean the airflow slots at the bot‐

tom of the appliance.

Clean the front surface of the

drum.

Adjust the dryness level.

Clean the condenser.

Remedy