AEG TR858P4B 사용자 설명서 - 페이지 24
{카테고리_이름} AEG TR858P4B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR858P4B 36 페이지.
페이지 인쇄
24
www.aeg.com
11.2 Troubleshooting
Problem
The tumble dry‐
er does not op‐
erate.
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
programme or
option.
It is not possible
to select an op‐
tion. An acoustic
signal is emit‐
ted.
Possible cause
The tumble dryer is not connected
to the mains supply.
The door is open.
The Aan/Uit button was not push‐
ed.
The Start/Pauze button was not
touched.
The appliance is in standby mode.
Incorrect programme selection.
The filter is clogged.
Droogtegraad option was set to
3)
strijkdroog .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possi‐
ble to change the programme or
option.
The option you tried to select is not
available for the selected pro‐
gramme.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Push the Aan/Uit button.
Touch the Start/Pauze button.
Push the Aan/Uit button.
Select a suitable programme.
2)
Clean the filter.
Change Droogtegraad option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
1)
4)
2)