AEG TR938H2C 사용자 설명서 - 페이지 25
{카테고리_이름} AEG TR938H2C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR938H2C 36 페이지.
페이지 인쇄
Problem
Incorrect programme selection.
The filter is clogged.
Stupeň sušení option was set to
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possible
After a cycle starts it is not possi‐
to change the
ble to change the programme or
programme or
option.
option.
It is not possible
The option you tried to select is not
to select an op‐
available for the selected pro‐
tion. An acoustic
gramme.
signal is emit‐
ted.
There is no
Defective drum lamp.
drum light
Unexpected du‐
The drying duration is calculated
ration time ap‐
according to load size and damp‐
pears on the
ness.
display.
The water container is full.
A programme is
inactive.
Possible cause
3)
suché k žehlení .
Remedy
Select a suitable programme.
2)
Clean the filter.
Change Stupeň sušení option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Contact the service centre to re‐
place the drum lamp.
This is automated - the appliance
is working correctly.
Drain the water container, push the
2)
Start/Pauza button.
ENGLISH
25
1)
4)
2)