AEG TR959M6BC 사용자 설명서 - 페이지 30
{카테고리_이름} AEG TR959M6BC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR959M6BC 36 페이지.
페이지 인쇄
30
www.aeg.com
12.2 Troubleshooting
Problem
The tumble dry‐
er does not op‐
erate.
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
program or op‐
tion.
It is not possible
to select an op‐
tion. An acoustic
signal is emit‐
ted.
There is no
drum light
Possible cause
The tumble dryer is not connected
to the mains supply.
The door is open.
The On/Off button was not pushed. Push the On/Off button.
The Start/Pause button was not
touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Dryness Level option was set to
3)
iron dry .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possi‐
ble to change the program or op‐
tion.
The option you tried to select is not
available for the selected program.
Defective drum lamp.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Touch the Start/Pause button.
Push the On/Off button.
Select a suitable program.
2)
Clean the filter.
Change Dryness Level option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
Contact the service centre to re‐
place the drum lamp.
1)
4)
2)