Kohler Sterling 71040110 설치 매뉴얼 - 페이지 5

{카테고리_이름} Kohler Sterling 71040110에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Sterling 71040110 44 페이지. Baths, afd baths, and wall surrounds

Roughing-In Illustrations (cont.)

If installing this bath with a shower door, refer to the shower door manufacturer's instructions for any

special framing considerations.

1. Framing Construction

Install the Framing

NOTE: Refer to the "Roughing-In" section for dimensions.

Install the subﬂoor if needed.

For installations with wall surrounds, ensure that the outer stud is aligned with the vertical wall

ﬂanges at 30" (76.2 cm) from the back wall. The outer stud edge should align with the wall ﬂange

edge.

Construct 2x4 stud framing for your particular installation according to the "Roughing-In" section.

Ensure that the framing for each stud is plumb and square to within 1/8" (3 mm). Shim as needed

to meet tolerances.

For baths with above-the-ﬂoor drains, ensure that the drain piping can pass through the wall, and

that the wall's load bearing requirements are satisﬁed. Modify the framing or raise the subﬂoor as

needed to obtain clearance.

Install the Accessories

IMPORTANT! For installations with wall surrounds, do not install accessories that require backing or

support. Such installation could void the warranty.

IMPORTANT! For installations with wall surrounds, do not allow ﬁber or other soft insulation to drop

down into the back channel, as this could damage the bath.

For installations with wall surrounds, cover or seal any loose material.

For bath only installations, provide the necessary backing or support for shelving, grab bars, towel

bars or other accessories. Refer to the accessory manufacturer's instructions.

Construct the Floor

IMPORTANT! Construct the ﬂoor of plywood. If the bath is installed over material other than plywood,

friction may cause squeaking over time.

IMPORTANT! Make sure the felt pad is properly positioned so that every bath-subﬂoor contact point has

felt between the bath and the subﬂoor.

Place the provided felt pad between the bath and the subﬂoor, positioned so that every

bath-subﬂoor contact point has felt between the bath and the subﬂoor.

For baths with through-the-ﬂoor drains, cut a hole in the ﬂoor for the drain line.

Verify that the subﬂoor is ﬂat and level. If the subﬂoor is not level, proceed to the "Level the Floor"

subsection.

IMPORTANT! Squeaking may develop if the bath is installed over a subﬂoor other than plywood. In

order to prevent squeaking place a pad between the bath and subﬂoor. The recommended pad material is

a spun bonded polyester landscape fabric, or spun bonded house wrap material. Do not use rooﬁng felt

for this purpose.

Level the Floor (If Needed)

NOTE: Use cement or mortar for this application. Gypsum cement or drywall compound will not provide

adequate support.

Sterling

1015404-2-D