Kohler Symbio K-1335-H 설치 매뉴얼 - 페이지 8

{카테고리_이름} Kohler Symbio K-1335-H에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Symbio K-1335-H 32 페이지. Bath whirlpool

Bond in accordance

with applicable codes

12. Install the Shower Door (Whirlpool/Receptor Combinations Only)

- Install the shower door according to the instructions packed with the shower door.

NOTE: The whirlpool model number is printed on a label near the whirlpool pump. This label also identifies the

electrical rating of the whirlpool.

WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump to a properly

grounded, grounding type receptacle protected by a Ground Fault Circuit Interrupter (GFCI). Do not remove

the plug's grounding pin. Do not use a grounding adapter.

- Your Kohler whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has been

completed at the factory. A licensed electrician must install a GFCI protected, 120 V, 20 A, grounded outlet. No

other load should be on this circuit. Locate the outlet behind the whirlpool, and within 24" (61cm) of the pump.

- Plug the pump into this outlet.

- Install the whirlpool trim kit according to the instructions packed with the trim kit. Pay particular attention to the

jet installation steps below - they are very important and are included here to help you obtain smooth,

trouble free jet operation.

NOTE: The jet O ring must be correctly positioned, must be lubricated, and must be in good condition to permit

easy rotation and proper operation of the jet.

- Install the O ring onto the first shoulder of the jet. Lubricate the O ring with silicone lubricant to prevent noisy

operation of the jet.

- Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into position. Do not

force the jet.

NOTE: When installed correctly, the jet should turn smoothly both clockwise and counterclockwise.

1012312-2-

Install a

GFCI-protected

120 V, 20 A

grounded outlet

Plug the pump

into this outlet

Housing

Slide the O-ring

onto the first

shoulder of the jet

Inspect and

lubricate the

O-ring

Insert the jet into the

housing, and lightly

push and rotate until

it snaps in position

Kohler Co.