Kohler 71120110-0 설치 및 관리 매뉴얼 - 페이지 22

{카테고리_이름} Kohler 71120110-0에 대한 설치 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 71120110-0 45 페이지.

(2)

Roofing Nail

Clou pour toiture

Clavo de techar

Wall Flange

Bride du mur

Reborde de la pared

(1)

Wall Tab

Languette du mur

Lengüeta de la pared

Bath Slot

Rainure de

la baignoire

Ranura de

la bañera

Pre-Fit the Wall Surrounds

NOTE: For baths without wall surrounds, proceed to the "Install the Finished Wall"

section.

IMPORTANT! Install the back wall ﬁrst.

NOTE: The appearance of your bath and wall surrounds may differ from the

illustration. The installation steps still apply.

Ensure the bath surface is free of debris. This will minimize the gaps between the

wall surrounds and the bath surface.

Position the back wall with the wall tabs engaged in the bath slots (1).

Temporarily install a rooﬁng nail or equivalent over the top of the back wall

ﬂange and into the center of a stud (2). Do not drive the nail in so far that it will

interfere with the end wall installation.

Position the end walls with the pins engaged in the wall slots on the back wall (3).

Ensure the wall tabs are still engaged in the bath slots. Do not secure the end

walls to the stud framing at this time.

Verify that the back wall is ﬂush against the bath. If adjustment is needed, remove

the rooﬁng nail from the back wall and reposition it. Reinstall the rooﬁng nail.

Verify that the end walls are ﬂush against the edge of the bath. If adjustment is

needed, push or pull the end walls to reposition them.

Verify that all walls are properly aligned with the studs at the top and vertical

wall ﬂanges. If needed, add shims to bring the studs into contact with the walls.

1064910-2-A

(3)

Wall Slot

Rainure du mur

Ranura de la

pared

Tige

Clavija

Sterling