Kohler Archer K-1124-RA-0 주택 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Kohler Archer K-1124-RA-0에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Archer K-1124-RA-0 24 페이지. Bath whirlpools

페이지 인쇄

Troubleshooting Procedures (cont.)

Symptoms

Whirlpool stops

automatically.

4. The motor starts but not

all jets function.

Noisy pump operation.

6. Heater does not operate

(units with heaters only).

1421656-5-A

Probable Causes

A. Pump has overheated and the

protection device has activated.

B. GFCI/RCD circuit has tripped.

A. Jets are closed.

B. Jets are blocked or trim ring

rotation is impeded.

C. Jets not installed correctly.

D. Pump is not supported correctly

and is cavitating.

A. The pump banding straps have

not been cut (models with support

blocks only).

A. No power to heater or it is not

connected to a separate outlet

from the pump.

B. The water temperature is above

104°F (40°C).

Recommended Action

A. Check for blockage at the motor

vents. Check for suction

blockage. Check for jet blockage.

Remove any blockage and allow

the motor to cool.

B. Identify source fault and correct.

Check that the GFCI/RCD has

not been tripped. If problem

persists, contact an electrician.

A. Rotate the jet trim ring

counterclockwise to

open/increase ﬂow to the jets.

B. Glue may be obstructing the jet

opening or preventing the jet trim

ring from rotating. Remove the

trim ring and remove excess glue.

C. Reinstall the jet; check for any

O-ring damage.

D. Review the installation instructions

and verify that the pump is a the

appropriate height and that the

pump banding straps (when

applicable) have been cut.

A. Using tin snips, cut pump

banding straps.

A. Verify that the heater is

connected to a separate outlet

from the pump and that the

connection has power.

B. As a safety precaution, the heater

will not operate when the water

temperature is above 104°F

(40°C).

Kohler Co.