Kohler Devonshire K-1357-GLA-47 설치 매뉴얼 - 페이지 6
{카테고리_이름} Kohler Devonshire K-1357-GLA-47에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Devonshire K-1357-GLA-47 48 페이지. Bath with airjets
Kohler Devonshire K-1357-GLA-47에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (29 페이지)
페이지 인쇄
1/16"
(2 mm)
Tile
Approved Tile Backing
2. Prepare the Site - Concrete Construction
NOTICE: Do not support the bath by the rim.
NOTICE: Refer to the Roughing-in Guide packed with this product for proper minimum lbs/square foot
(kg/square meter) floor support loading.
NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed
location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor
closer than 1" (2.5 cm) from the wall or other objects.
Make sure the flooring offers adequate support for your bath, and verify that the subfloor is flat and
level.
Construct brick or concrete supports.
Provide a 1/16" (2 mm) gap between the bath rim and the concrete or brick framing. Frame the
floor, or construct a frame for a raised installation, in accordance with the roughing-in information
packed with the bath.
Position the plumbing according to the roughing-in information packed. Cap the supplies, and
check for leaks.
3. Prepare the Bath with Airjets
Install the drain to the bath according to the drain manufacturer's instructions. Do not connect the
trap at this time.
Position a clean drop cloth or similar material in the bottom of the bath to protect the finish. Be
careful not to scratch the surface of the bath.
1040292-2-E
Bath
Brick
Tile
Approved Tile Backing
Brick
6
Apron Side
Kohler Co.