Kohler K-1106-S 설치 매뉴얼 - 페이지 4

{카테고리_이름} Kohler K-1106-S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1106-S 28 페이지. System basic drop-in bath whirlpool

페이지 인쇄
Kohler K-1106-S 설치 매뉴얼
Position
the rough
plumbing
Verify that the subfloor
offers adequate support,
and is flat and level

1. Prepare the Site

NOTICE: Unless otherwise specified, floor support under the whirlpool must provide for a minimum of 80
lbs./square foot (390 Kg./square meter) loading.
NOTICE: Do not support the whirlpool by the rim.
- Make sure the flooring offers adequate support for your whirlpool, and verify that the subfloor is flat and level.
- The whirlpool should be installed in a drop in, corner, or alcove installation. Construct 2x4 stud framing designed
for your particular installation. Frame the floor, or construct a frame for a raised installation in accordance with
the roughing in information packed with the whirlpool.
- Carefully lay out and cut the rough deck material. Use the cut out template if one is provided, or refer to the
roughing in cut out information.
- Position the plumbing according to the roughing in information packed. Cap the supplies, and check for leaks.

2. Prepare the Whirlpool

- We recommend a tiling in bead for straight rimmed whirlpools if one or more sides of the whirlpool contact a
wall. This bead prevents water from seeping between the whirlpool rim and the wall. Follow the instructions
packed with the tiling in bead to install the bead now.
- Install the drain to the whirlpool according to the drain manufacturer's instructions. Do not connect the trap at
this time.
- Position a clean drop cloth or similar material in the bottom of the whirlpool. Be careful not to scratch the surface
of the product.
A
1011585-2-
Position
the rough
Construct
plumbing
2x4 stud
framing
according to
the
roughing-in
information
Verify that the subfloor
offers adequate support,
and is flat and level
4
Frame the floor
according to the
roughing-in
information
Kohler Co.