Kohler K-1107 설치 매뉴얼 - 페이지 6

{카테고리_이름} Kohler K-1107에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1107 25 페이지. Drop-in acrylic baths
Kohler K-1107에 대해서도 마찬가지입니다: 설치 매뉴얼 (25 페이지), 설치 및 관리 매뉴얼 (29 페이지), 설치 및 관리 매뉴얼 (25 페이지)

페이지 인쇄

Nail 1/4" (6 mm)

thick furring strips

to the studs.

Stud

Use #6 large-head galvanized

nails to secure the nailing-in

flange to the studs.

5. Secure the Bath to the Stud Framing

Drill a small pilot hole through the nailing–in ﬂange at each stud location. Add shims between the

nailing-in ﬂange and the studs as needed to eliminate any gaps.

Nail 1/4" (6 mm) thick furring strips to the studs to shim out to the edge of the nailing-in ﬂange.

Use #6 large-head galvanized nails or screws to secure the nailing-in ﬂange to the studs.

6. Install the Plumbing

CAUTION: Risk of personal injury. Bath rim-mounted faucets that may be inadvertently used as a

means of support are not appropriate or safe for this installation.

CAUTION: Risk of property damage. Make sure a watertight seal exists on all bath drain connections.

NOTE: Provide access to all plumbing connections to simplify future maintenance.

Connect the trap to the drain according to the drain manufacturer's instructions.

Install the faucet valving according to the faucet manufacturer's instructions. Do not install the

faucet trim at this time.

Open the hot and cold water supplies and check all connections for leaks.

Run water into the bath and check the drain connections for leaks.

Fill the bath to the overﬂow and check for leaks.

1016757-2-C

Drill a small hole through

the nailing-in flange at

each stud.

Kohler Co.