Kohler K-1150 설치 매뉴얼 - 페이지 5

{카테고리_이름} Kohler K-1150에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1150 21 페이지. Flanged acrylic bath with integral apron

4. Secure the Bath to the Stud Framing

Drill a small pilot hole through the nailing–in ﬂange at each stud location. Add shims between the

nailing-in ﬂange and the studs as needed to eliminate any gaps.

Nail 1/4" (6 mm) thick furring strips to the studs to shim out to the edge of the nailing-in ﬂange.

Use #6 large-head galvanized nails or screws to secure the nailing-in ﬂange to the studs.

5. Install the Plumbing

CAUTION: Risk of property damage. Make sure a watertight seal exists on all bath drain connections.

Connect the trap to the drain according to the drain manufacturer's instructions.

Install the faucet valving according to the faucet manufacturer's instructions. Do not install the

faucet trim at this time.

Open the hot and cold water supplies and check all connections for leaks.

Run water into the bath and check the drain connections for leaks.

Fill the bath to the overﬂow and check for leaks.

Kohler Co.

Nail 1/4" (6 mm)

thick furring strips

to the studs.

Stud

Use #6 large-head

galvanized nails to secure

the nailing-in flange to the

studs.

Drill a small hole

through the nailing-in

flange at each stud.

1014139-2-D